Cooper-instruments-systems DFR 1250 Two Channel Paperless Recorder Manuale Utente Scaricare il pdf (Pagina 4)

TSFM 500 DC 2 32-1101 REV 2 710

In general, the controller can be mounted at any angle, although extra care should be taken during installation and

operation.

3.2 Setting up the Controller

The power plug and controller cable must be connected to the rear of the controller, as shown in the illustration below:

1. Fuse

2. STAND / Controller Cable Connector

Plug one end of the cable into this connector, and the other end into the connector adjacent to the motor on the test

stand. If this cable is not connected, the error message ENCODER ERROR will be shown on the display and the test

stand cannot be operated.

3. PC / PC Control Connector

Plug one end of the 09-1056 serial cable into this connector, and the other end into a serial connector on a computer.

4. Power Plug Receptacle

Plug the power cord in here.

5. ENCODER / Travel Indication Connector

1 2 3 4 5 6 7 8 9 ... 21 22

Nessun commento

Cooper-instruments-systems DFR 1250 Two Channel Paperless Recorder Manuale Utente Pagina 4